Codal
nydus/The Principles of Chemistry, Volume IPublic
Page 493 of 868
Table of Contents

In the expanded upper portion c, two tubes are sealed; one, e, for drawing in the gas, whilst the other, b, is connected to the water supply w. The amount of water supplied through the tube b must be less than the amount which can be carried off by the tube d. Owing to this the water in the tube d will flow through it in cylinders alternating with cylinders of gas, which will be thus carried away. The gas which is drawn through may be collected from the end of the tube d, but this form of pump is usually employed where the air or gas aspirated is not to be collected. If the tube d is of considerable length, say 40 ft. or more, a very fair vacuum will be produced, the amount of which is shown by the gauge g; it is often used for filtering under reduced pressure, as shown in the figure. If water be replaced by mercury, and the length of the tube d be greater than 760 mm., the aspirator may be employed as an air-pump, and all the air may be exhausted from a limited space; for instance, by connecting g with a hollow sphere. Gasholders are often used for collecting and holding gases. They are made of glass, copper, or tin plate. The usual form is shown in fig. 23. The lower vessel B is made hermetically tight—i.e., impervious to gases—and is filled with water. A funnel is attached to this vessel (on several supports).

493