Codal
nydus/The Principles of Chemistry, Volume IPublic
Page 658 of 868
Table of Contents

In a word, although these methods of determining the molecular weight of substances in solution show an undoubted progress in the general chemical principles of the molecular theory, there are still many points which require explanation. We will add certain general relations which apply to these problems. Isotonic (Chapter I., Note 66) solutions exhibit not only similar osmotic pressures, but also the same vapour tension, boiling point and freezing temperature. The osmotic pressure bears the same relation to the fall of the vapour tension as the specific gravity of a solution does to the specific gravity of the vapour of the solvent. The general formulæ underlying the whole doctrine of the influence of the molecular weight upon the properties of solutions considered above, are: 1. Raoult in 1886–1890 showed that p - p′ / p · 100 / a · M / m = a constant C where p and p′ are the vapour tensions of the solvent and substance dissolved, a the amount in grms. of the substance dissolved per 100 grms. of solvent, M and m the molecular weights of the substance dissolved and solvent. 2. Raoult and Recoura in 1890 showed that the constant above C = the ratio of the actual vapour density d′ of the solvent to the theoretical density d calculated according to the molecular weight.

This deduction may now be considered proved, because both the fall of tension and the ratio of the vapour densities d′/d give, for water 1·03, for alcohol 1·02, for ether 1·04, for bisulphide of carbon 1·00, for benzene 1·02, for acetic acid 1·63. 3. By applying the principles of thermodynamics and calling L1 the latent heat of fusion and T1 the absolute (= t + 273) temperature of fusion of the solvent, and L2 and T2 the corresponding values for the boiling point, Van't Hoff in 1886–1890 deduced:— Depression of freezing point / Rise of boiling point = L2 / L1 · T12 / T22 Depression of freezing point = AT12a / L1M1 Rise of boiling point = AT22a / L2M1 where A = 0·01988 (or nearly 0·02 as we took it above), a is the weight in grms. of the substance dissolved per 100 grms. of the solvent, M1 the molecular weight of the dissolved substance (in the solution), and M the molecular weight of this substance according to its composition and vapour density, then i = M/M1. The experimental data and theoretical considerations upon which these formulæ are based will be found in text-books of physical and theoretical chemistry.

30

A similar conclusion respecting the molecular weight of liquid water (i.e. that its molecule in a liquid state is more complex than in a gaseous state, or polymerized into H8O4, H6O3 or in general into nH2O) is frequently met in chemico-physical literature, but as yet there is no basis for its being fully admitted, although it is possible that a polymerization or aggregation of several molecules into one takes place in the passage of water into a liquid or solid state, and that there is a converse depolymerization in the act of evaporation. Recently, particular attention has been drawn to this subject owing to the researches of Eötvös (1886) and Ramsay and Shields (1893) on the variation of the surface tension N with the temperature (N = the capillary constant a2 multiplied by the specific gravity and divided by 2, for example, for water at 0° and 100° the value of a2 = 15·41 and 12·58 sq. mm., and the surface tension 7·92 and 6·04). Starting from the absolute boiling point (Chapter II., Note 159) and adding 6°, as was necessary from all the data obtained, and calling this temperature T, it is found that AS = kT, where S is the surface of a gram-molecule of the liquid (if M is its weight in grams, s its sp. gr., then its sp.

658